Site icon Soundproof Guide

How to Stop Footstep Noise From Upstairs: DIY to Pro

How to stop footstep noise from the floor above, DIY to pro

Most ceiling soundproofing advice starts with insulation or another sheet of drywall. But if the noise is footsteps, you could spend a lot of money and still hear every single step.

In this article I’ll go through which fixes actually help with footsteps, which ones help with voices and TV, and how I’d build a ceiling if I wanted the biggest improvement possible, starting with DIY and working up to pro.

First, figure out what kind of noise it is

Before you touch the ceiling, figure out how the noise is getting into the room.

That’s why a fix that makes conversations quieter might do very little for the thumping. Keep that in mind as you go through the options below.

Start upstairs: a rug and a good pad

If footsteps are the problem and you have access to the room upstairs, this is the first thing I’d try. It’s also one of the most useful fixes for footsteps, because it’s a lot easier to deal with an impact before it shakes the floor.

Test it before you buy a big rug:

  1. Walk across the bare floor upstairs and record the sound downstairs.
  2. Put down a rug and pad.
  3. Repeat in the same shoes and the same position, and compare.

The pad matters. A rug with a decent pad underneath takes some of the sharp impact out of each footstep before it gets into the floor. A thin rug on its own might make the room feel a little less echoey, but it won’t do much for anybody downstairs.

Live in an apartment and can’t go put a rug in your neighbor’s place? Then we work from below.

Seal the easy openings in the ceiling

Before buying drywall or insulation, look around the ceiling. Check where it meets the wall, and look around any lights, pipes or other openings. If you can clearly hear people talking upstairs, a gap gives that sound an easier way through, and sealing it is the cheap place to start.

I use acoustic sealant because it stays flexible over time, unlike regular painter’s caulk. A caulking dispenser makes the job a lot easier.

I don’t want to oversell this. If your ceiling is already well sealed, this might make almost no difference, and it’s not going to stop footsteps. But if there are openings, I’d rather deal with them now than cover everything up with drywall.

Adding a layer of 5/8″ drywall

Adding drywall is probably the first thing people think of when they want to soundproof a ceiling. For voices or TV noise it can help, because you’re putting more weight between you and the sound. I’d use 5/8″ drywall and make sure the edges are sealed.

If you’re doing the work yourself, a drywall lift will make your life a whole lot easier. Holding a full sheet over your head while you try to screw it in doesn’t go over well.

Here’s the catch: the new drywall is still attached to the same ceiling. When someone walks upstairs, those vibrations travel through the floor framing and into the drywall you just installed. So I’d look at this as a reasonable upgrade for voices and TV, not the fix I’d use for heavy footsteps.

I also won’t give you a magic “this will cut noise by 50%” number, because I don’t know what’s already inside your ceiling. Every ceiling is different. You might have insulation up there or you might not, and the way it’s built will make a difference.

With the ceiling open: insulation

If you have an open ceiling, or you can rip the drywall off and start from scratch, the first thing to check is whether there’s any insulation. If the spaces between the joists are empty, fill them with mineral wool or fiberglass batts.

Mineral wool, like Rockwool, is a little more expensive than typical pink fiberglass, but it’s more meant to absorb noise inside the cavity. It won’t make a world of difference compared with fiberglass, but if you’re insulating specifically for noise and not for heat and cold, I’d use the one made for sound.

Fit it so it fills the cavity without cramming it in. This helps with voices and TV from upstairs, but insulation by itself isn’t going to stop the joists from vibrating.

The important part for footsteps: isolation clips and channel

This is where you actually deal with footsteps: isolating the new ceiling from the joists.

It sounds like a small difference, but the drywall is no longer directly attached to every joist above it, and that’s what we’re after. Most of the vibration now gets spread out through the channel instead of traveling down the joists and into your room. Follow the clip manufacturer’s layout and screw requirements, and take your time with it.

Seal electrical boxes and recessed lights

Electrical boxes are full of holes. Wrap each box and fixture with putty pads, a moldable, fire-rated sheet that creates an airtight seal. Press it firmly around every corner so no seams are exposed. These pads only cost a few dollars, but they’re essential for stopping air and sound leaks around wiring and fixtures.

Finish with two layers of drywall and MLV

For the finish, I’d use two layers of 5/8″ drywall if the assembly can support them. Stagger the seams between the layers and seal around the perimeter. It’s a lot of work overhead, but you want to squeeze every bit of performance out of the ceiling.

Then add mass loaded vinyl (MLV) between the two layers. MLV is a dense, flexible sheet designed to block sound without taking up much space. Sandwiched between two layers of drywall, it gives the ceiling a big boost in density, and that extra mass is especially effective against the lower-frequency noise regular drywall struggles with.

How to install the MLV:

  1. Cut it to fit the ceiling exactly.
  2. Lay it flat against the first layer of drywall and staple or tack it in place.
  3. Don’t overlap the seams. Butt the edges together and seal them with acoustic seam tape.

Back upstairs: underlayment when you replace the floor

If you own the place and don’t want to rip out your basement ceiling, start with a thick rug and pad like we talked about earlier. But if you’re replacing the upstairs floor anyway, you can go a lot further.

For laminate or engineered wood, there are two products I’d recommend: QuietWalk Plus and ROBERTS Super Felt. Both are felt-like underlayments around 3 mm thick. Neither is a sponsor. I also linked a thick floor underlayment and a rubber underlayment in the video description.

Two warnings before you buy:

Footsteps vs. voices: what to expect

FixVoices / TVFootsteps
Rug + pad upstairsSomeYes, one of the best first steps
Sealing ceiling gapsYes, if there are gapsNo
Extra layer of 5/8″ drywallYesNot much
Insulation in the cavityYesNot on its own
Isolation clips + hat channelYesYes, the key fix
Two layers of drywall + MLVYesYes, with clips
Underlayment under a new floorSomeYes

If you live in an apartment

Voices are a lot easier to soundproof than footsteps, because you don’t have to separate the whole ceiling. In an apartment you’ll have fewer choices, but you still have some, and there are ways to soundproof without losing your damage deposit. My apartment soundproofing video walks through them.

Jump to a part of the video

Products from the video

As an Amazon Associate I earn from qualifying purchases. Using these links supports Soundproof Guide at no extra cost to you.

My Amazon storefront

Exit mobile version